Tascam Sonicview 16 Bedienungsanleitung Seite 20

o Tap the ALL SEND ( ) button on the right edge of the Home
Screen to show the SEND levels of all MIX 1–22/FX 1–4 buses
in the SEND area (c area in "Setting various parameters on
the Home Screen" on page 13). Tap this display to switch to
showing the SEND buses in the tapped area.
PAN settings
Tap the PAN area (d area in "Setting various parameters on the
Home Screen" on page 13) on the Home Screen to show the
selection frame, enabling PAN adjustment using the LCD knobs
(2).
MAIN L/R assignments
o The MAIN L/R bus assignment status is shown above and to
the right of the pan/balance setting in the PAN area (d area
in "Setting various parameters on the Home Screen" on page
13) on the Home Screen.
o Tap the PAN area selection frame on the Home Screen to
open the MODULE (SEND/PAN) screen of the tapped channel
module. Tap the L/R button at the bottom right of the screen
to change the MAIN L/R bus assignment settings.
NOTE
Assignments can also be checked and changed on the ON/
OFF (INPUT) page of the MAIN L/R master module SEND
OVERVIEW Screen. Open this using Menu Screen > Mixer
Setup menu > Main L/R Assign Overview item.
MUTE keys
Press a MUTE key (3) to mute/unmute.
When a MUTE key is on (lit), the signal of the corresponding
module is muted.
SOLO keys
Using the default factory settings, multiple SOLO keys (4) can
be pressed to enable solo monitoring of signals mixed from
multiple channel modules.
SOLO settings can be changed on the MONITOR SETUP Screen.
Open this using Menu Screen > Mixer Setup menu > Monitor/
Solo Setup item.
NOTE
The MONITOR SETUP screen MONITOR/SOLO page can also
be opened by pressing one of the following buttons while
pressing the MENU key (q).
• Press any SOLO key (4) while pressing the MENU key (q)
20
TASCAM Sonicview 16/Sonicview 24
• Press the SOLO CLEAR key (r) while pressing the MENU
key (q)
SEL keys
Press a channel section SEL key (5) or the master section SEL
key (y) to open the MODULE Screen for the selected channel.
Tap the desired screen selection button at the top of the
MODULE screen, and use the touchscreen (1) and LCD knobs
(2) to set various parameters.
Faders
The 16 channel faders of Sonicview 16 and the 24 channel
faders of the Sonicview 24 show the SEND levels to the
following buses.
o MAIN L/R bus when the SENDS ON FADER key (k) is off
(unlit)
o Selected MIX SEND/FX SEND bus when the SENDS ON FADER
key (k) is on (lit)
Use LAYER KEYS 1–7 (p) to switch layers. Then, use the faders to
adjust the levels of each module.
The MASTER fader (a) controls the master SEND level of the
selected bus.
Copy/Paste
Tap the button at the top right of the MODULE Screen to
open the MODULE pull-down menu.
Parameters can be copied and pasted using the MODULE menu.
Parameters that can be copied and pasted differ according to
the open MODULE screen.
To copy or paste all the parameters of the selected channel
module, execute Copy MODULE or Paste MODULE in this
MODULE menu.