Master Fader; User Defined Control - Tascam Sonicview 16 Bedienungsanleitung

MASTER fader

Modules can be assigned as desired to the MASTER fader (MAIN
L/R assigned by default).
Change settings for the MASTER fader from the Custom Layer
SETUP page. Open this using Menu Screen > Front Panel Setup
menu > Layer/Master Fader Setup item.

User Defined Control

Various functions and operations can be assigned to the 18
USER KEYS, a Foot Switch, and the 8-input/8-output GPIO port.
Change settings for the USER KEYS on the User Key Setup page.
Open this using Menu Screen > Front Panel Setup menu > User
Key Setup item.
Change footswitch settings on the Foot Switch page. Open this
using Menu Screen > Rear Panel Setup menu > FOOT SW Setup
item.
Default settings for USER KEYS A-F/1–12
Key Lit color Assigned function
USER KEYS A Green Monitor Source Select 1 (MAIN L/R)
USER KEYS B Green Monitor Source Select 2 (MIX15-16)
USER KEYS C Red Monitor MUTE
USER KEYS D Green Monitor Source Select 3 (MIX1)
USER KEYS E Green Monitor Source Select 4 (MIX11-12)
USER KEYS F Orange Monitor DIM
USER KEYS 1 Red Mute Group 1
USER KEYS 2 Red Mute Group 2
USER KEYS 3 Red Mute Group 3
USER KEYS 4 Red Mute Group 4
USER KEYS 5 Orange Sends On Fader Mix1
USER KEYS 6 Orange Sends On Fader Mix2
USER KEYS 7 Orange Sends On Fader Mix3
USER KEYS 8 Orange Sends On Fader Mix4
USER KEYS 9 Orange Sends On Fader Mix5
USER KEYS 10 Orange Sends On Fader Mix6
USER KEYS 11 Orange Sends On Fader Mix7
USER KEYS 12 Orange Sends On Fader Mix8
16
TASCAM Sonicview 16/Sonicview 24
Default Foot Switch setting
Assigned function
Tap Tempo FX3 Delay1
GPIO settings
Change GPIO settings on the GPIO-IN/GPIO-OUT pages. Open
these using Menu Screen > Rear Panel Setup menu > GPIO Input
Setup/GPIO Output Setup items.
The pin assignments are as follows.
Pin No. Function
1 GND
2 GPIO IN 2
3 GPIO IN 4
4 GPIO IN 6
5 GPIO IN 8
6 NC
7 NC
8 NC
9 GPIO OUT 2
10 GPIO OUT 4
11 GPIO OUT 6
12 GPIO OUT 8
13 NC
14 GPIO IN 1
15 GPIO IN 3
16 GPIO IN 5
17 GPIO IN 7
18 NC
19 NC
20 GND
21 GPIO OUT 1
22 GPIO OUT 3
23 GPIO OUT 5
24 GPIO OUT 7
25 +5V
IN: For command input
i Internal circuit with +5V pull-up
i Operates with low signal input of 50 msec or longer
OUT: For command and tally output
i Internal circuit is open collector (10Ω output
impedance)
i 20V dielectric strength, 35mA maximum current
+5V: 50mA maximum supplied current
IN/OUT
-
IN
IN
IN
IN
-
-
-
OUT
OUT
OUT
OUT
-
IN
IN
IN
IN
-
-
-
OUT
OUT
OUT
OUT
-