User Defined Control Functions List - Tascam Sonicview 16 Bedienungsanleitung

User Defined Control functions list

The following functions can be assigned to user defined controls (USER KEYS, FOOTSWITCH, GPIO IN and GPIO OUT).
These functions can be assigned to each control on the USER DEFINED CONTROLS Screen.
User Key, Foot Switch and GPIO-IN pages
Function Parameter1
Tap Tempo FX1-4
Mute Group 1-8
Sends On Fader Mix1-22/FX1-4
Select
Recall
Snapshot
Store
Target
Undo/Redo
Parameter2 Parameter3
Delay1-3
Next
Prev
No 1-128/P001-Pxxx
Selected
Next
Prev
No 1-128/P001-Pxxx
+Target Key
Selected
No 1-128
+Target Key
Selected
Next
Prev
No 1-128/P001-Pxxx
Undo Color Redo Color
Function explanation
Use to tap the tempo to input the DELAY TIME when
the selected effect type is DELAY.
Turn the selected Mute Group on/off.
Turn the Sends On Fader mode for the selected bus
on/off.
Increase by one the number of the Snapshot available
for STORE/RECALL shown at the top of the Menu
Screen.
Decrease by one the number of the Snapshot
available for STORE/RECALL shown at the top of the
Menu Screen.
This makes the specified Snapshot number shown
at the top of the Menu Screen the target for STORE/
RECALL.
Recall the Snapshot available for RECALL shown at
the top of the Menu Screen.
Switch the number of the Snapshot available for
RECALL shown at the top of the Menu Screen to the
Snapshot that is one later, and then recall it.
Switch the number of the Snapshot available for
RECALL shown at the top of the Menu Screen to the
Snapshot that is one earlier, and then recall it.
Recall a snapshot by number.
Press this simultaneously with a key that has Function
set to Snapshot and Parameter 1 set to Target to recall
that set snapshot number.
Store the Snapshot available for STORE shown at the
top of the Menu Screen.
Store a snapshot by number.
Press this simultaneously with a key that has Function
set to Snapshot and Parameter 1 set to Target to
store in that set snapshot number. However, even
when Function is set to Snapshot and Parameter 1 is
set to Target, this will not work if the key assigned to
Parameter 2 as "Next" or "Prev" is pressed at the same
time.
Press simultaneously with a key assigned to a
+Target Key function to STORE to or RECALL from
the Snapshot number shown at the top of the Menu
Screen.
Press simultaneously with a key assigned to a +Target
Key function to make the Snapshot number target for
STORE/RECALL one after that shown at the top of the
MENU Screen subject to RECALL.
Press simultaneously with a key assigned to a +Target
Key function to make the Snapshot number target for
STORE/RECALL one before that shown at the top of
the MENU Screen subject to RECALL.
Press simultaneously with a key assigned to a
+Target Key function to STORE to or RECALL from the
specified Snapshot number.
Undo/redo Snapshot RECALL operations.
Use Parameters 2 and 3 to set the colors that the
USER KEYS light when Undo/Redo can be executed.
Undo Color and Redo Color can only be set for USER
KEYS.
TASCAM Sonicview 16/Sonicview 24
17