Instructions Before Use; Filling With Water - SOLAC CE4520 Gebrauchsanweisung

Downloaded by: pd-oliana on 12-08-2022 14:11 CEST
ENGLISH
Dear customer,
Thank you for deciding to purchase a Solac brand pro-
duct.
Thanks to its technology, design and operation and the
fact that it exceeds the strictest quality standards, a fully
satisfactory use and long product life can be assured.
Read these instructions carefully before switching on
the appliance and keep them for future reference. Fai-
lure to follow and observe these instructions may result
in an accident. Failure to follow and observe these ins-
tructions may result in an accident.
USE AND CARE:
Do not use the appliance if its accessories are not pro-
perly fitted.
Do not switch the appliance on without water.
Do not use the appliance if the ON/OFF switch does
not work.
Do not move the appliance while in use.
Respect the MAX and MIN levels.
Disconnect the appliance from the mains when not in
use and before undertaking any cleaning task.
Store this appliance out of reach of children and/or tho-
se with reduced physical, sensorial or mental abilities or
who are unfamiliar with its use.
Do not put the appliance away if it is still hot.
Only use water with the appliance.
Never leave the appliance connected and unattended if
not in use. This also saves energy and prolongs the life
of the appliance.
Do not remove the filter holder when coffee is being
made, as at that time it is under pressure.
DESCRIPTION
A Cup warming plate
B Steam/water control
C Steam heating button
D 2-coffee button
E 1-coffee button
F Drip tray
G Tank lid
H Water tank
I Steamer pipe
J Start/stop button
K Filter for single measure
L Filter for double measure
M Filter for capsules *
N Filter holder
O Measuring spoon with compactor
P Pressure gauge
(*) Only available on Taste Slim ProCAP model (CE4523)
If your model of appliance does not have the accessories described above, they can purchased separately from the Technical Assistance Service.
INSTRUCTIONS
BEFORE USE:
Make sure that all the product's packaging material
has been removed.
When using this product for the first time, it is advisa-
ble to test it with just water.
Before using the product for the first time, clean the
parts that will come into contact with food in the man-
ner described in the cleaning section.
Before switching the machine on, check that there
is nothing pressing the buttons and that the steam
controller is closed.

FILLING WITH WATER:

The tank must be filled with water before turning the
appliance on.
Remove the tank from the appliance.
Open the lid
Fill the tank with cold water.
Fill the container, respecting the MAX level.
Close the lid.
Replace the tank in its housing, ensuring that it is well
fitted.
PRESSURE INDICATOR
The pressure gauge (P) indicates whether the pressu-
re is optimal for the task in hand, when the pointer is in
the OPTIMAL PRESSURE region.
PRIMING THE CIRCUIT
This simple operation ensures optimum dispensing
and has to be performed:
• When first starting:
• When the machine has not been used for a long
time (1 or 2 weeks)
• After producing steam
• When the tank has run out of water.
Fill the tank with water, making sure not to exceed the
"MAX" level marker.
Connect the appliance to the mains.
Set the On/Off switch (J) to the On position. The pilot
light will light up
For this operation it is not necessary to wait for the
machine to heat up
Without fitting the filter holder, (or with the filter holder
fitted, but without coffee), place a container below the
steam tube (I)
Open the steam control (B) by turning it anti-clockwise.
The pump will start to operate, taking water from the
tank.
Water will come out through the steam pipe. Wait until
approximately one cupful has come out.
To finish the operation, close the steam control (B) by
turning it clockwise.
This will complete the priming operation.
EN