Before Use - SOLAC CE4502 Gebrauchsanweisung

ENGLISH
COFFEE-MAKER
CE4502 - CE4503 - CE4504
CE4505 - CE4506
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not switch the appliance on without water.
- Do not use the appliance if the on/off switch
does not work.
- Do not move the appliance while in use.
- Respect the MAX and MIN levels.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Unplug the appliance from the mains before
refilling the water tank.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Do not store the appliance if it is still hot.
- Only use water with the appliance.
- The use of bottled mineral water adapted for
human consumption is recommended.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not remove the filter-holder when coffee is
being made, as at that time it is under pressure.
DESCRIPTION
A Water Tank Level
B Water tank
C Hot plate for warming cups
D Pilot light: ON/OFF
E Pilot light: Temperature
F ON/OFF Switch (Back of the machine)
G0 Central position (Stop)
G1 Coffee/Water Position
G2Heating for Steam position
H Function Selector knob
I Steamer/Hot water pipe
J Filter holder
K Measuring spoon
L Filter for single measure (or POD)
M Ground coffee filter (2 cups)
N Supply cable
O Drip tray
P Silicone tubes
R Steam/Water Knob
INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all the product's packaging has
been removed.
- Remove the protection of the suction tubes
from the tank, at the rear of the machine. All
machines have been tested with water, that
protection is to prevent dripping during trans-
port.
- Before using this product for the first time, it is
advisable to test it only with water.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
- Before connecting the machine, check that
Steam/Water Knob (R) is closed.
PRIMING THE CIRCUIT
This simple operation ensures optimum dispens-
ing and must be carried out:
- When first starting.
- When the machine remains a long period with-
out being used (1 or 2 weeks).
- After obtaining steam.
- When the tank has run out of water.
- Fill the receptacle taking care to observe the
MAX level.
- Connect the appliance to the mains.
- Push the ON/OFF switch (F) on the back of the
machine.
- The (D) pilot light will light, indicating that ma-
chine is connected.
- You do not must wait for the machine to heat
up for this operation.
EN