Before Use; Filling With Water - SOLAC CE4483 Gebrauchsanleitung

Downloaded by: pd-oliana on 12-08-2022 13:13 CEST
EN
(Original instructions)
USE AND CARE
Do not use the appliance if its accessories are
not properly fitted.
Do not switch the appliance on without water.
Do not use the appliance if the on/off switch
does not work.
Do not move the appliance while in use.
Respect the MAX and MIN levels
Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
Unplug the appliance from the mains before re-
filling the water tank.
Store this appliance out of reach of children and/
or persons with physical, sensory or reduced
mental or lack of experience and knowledge.
Do not store the appliance if it is still hot.
Only use water with the appliance.
The use of bottled mineral water adapted for hu-
man consumption is recommended.
Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
Do not remove the filter holder when coffee is
being made, as at that time it is under pressure.
DESCRIPTION
A Water Tank Lid
B Water tank
C Hot plate for warming cups
D Connection pilot light
E Heating pilot light
F ON/OFF Switch
G Coffee outlet/Water outlet Switch
H Steam heating Switch
I Steamer pipe
J Filter holder
K Measuring spoon
L Ground coffee filter (1 cup)
M Ground coffee filter (2 cups)
N Supply cable
O Drip tray
P Tray grill
R Steam knob
Libro 1.indb 7 Libro 1.indb 7
INSTRUCTIONS FOR USE

BEFORE USE:

Make sure that all the product's packaging has
been removed.
Before using this product for the first time, it is
advisable to test it only with water.
Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
Before connecting the machine, check that the
buttons (F, G) are not pressed, and steam con-
trol (R) is closed
PRIMING THE CIRCUIT:
This simple operation ensures optimum dis-
pensing and must be carried out:
When first starting:
When the machine has been out of use for a
long time (1 or 2 weeks)
After making steam
WHEN THE TANK HAS RUN OUT OF WATER.
Fill the receptacle taking care to observe the
MAX level
Connect the appliance to the mains.
Press the on/off switch (F) to ON position. The
(D) pilot light will come on
You do not have to wait for the machine to heat
up for this operation
Without fitting the filter holder (or with the filter
holder fitted, but without coffee), place a recipi-
ent under the steam pipe (I)
Open the steam knob (R) by turning counter-
clockwise
Press the coffee switch / water (G) to ON po-
sition
Water will exit through the steam pipe. Wait until
approximately one cupful has exited
o finish serving, back coffee / water switch to
OFF position and close the steam knob (R) by
turning clockwise
This will complete the priming operation.

FILLING WITH WATER:

The tank must be filled with water before turning
the appliance on.
Remove the water tank.
Open the cover.
Fill the tank taking care to observe the MAX lev-
el (Fig. 1)
Close the lid.
7/3/22 11:12 7/3/22 11:12