Description Of Control Mode; Assisted Fault Advice; Priority Of Settings - Grundfos MGE Serie Montage- Und Betriebsanleitung

15. Press the Right button to continue.
16. Press OK to confirm the setting.
The multipump or multimotor function icons appear at the bottom of the operating panels.
6.46.5 Disabling a multipump or multimotor system with Grundfos GO Remote
1. Go to Assist.
2. Select Multi-pump setup and press Disable.
3. Press the Right button to continue.
4. Confirm the setting by pressing Send.
5. Press Finish.
6.46.6 Disabling a multipump or multimotor system with the advanced operating panel
1. Go to Assist.
2. Select Setup of multi-pump system.
3. Press the Right button to continue.
4. Press OK to confirm No multi-pump function.
5. Press the Right button to continue.
6. Press OK to confirm.

6.47 "Description of control mode"

The function is only available in the advanced operating panel.
The function describes each of the control modes available for the product.
Related information
6.5 "Control mode"

6.48 "Assisted fault advice"

This function provides guidance and corrective actions in the event of product failure.

6.49 Priority of settings

With Grundfos GO Remote, you can set the motor to operate at maximum speed or to stop.
If two or more functions are enabled at the same time, the motor operates according to the function with the highest priority.
If you have set the motor to maximum speed via the digital input, the motor operating panel or Grundfos GO Remote can only set the motor
to Manual or Stop.
The priority of the settings appears from the table below:
Start/stop Grundfos GO Remote or operating panel on
Priority
button motor
1 Stop
2 Stop
3 Manual
4 Maximum speed / User defined speed
5
6
7
8
9
10
11
12 Minimum speed
13
14
15 Start
* Stop and Maximum speed settings made with Grundfos GO Remote or on the motor operating panel can be overruled by another operating-mode command
sent from a bus, for example Start. If the bus communication is interrupted, the motor resumes its previous operating mode, for example Stop, that was
selected with Grundfos GO Remote or the motor operating panel.
Related information
6.8 "Digital inputs"
6.15 "Predefined setpoints"
60
*
Digital input
*
Stop
User defined speed
Maximum speed
Minimum speed
Start
Bus communication
Stop
Maximum speed / User defined
speed
Minimum speed
Start