Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Press the Menu icon in the upper left corner of Grundfos GO Remote.
3. Go to General > Settings > Remote.
4. Enter the preset connection code in the Preset connection code field and press OK.
To change the preset connection code, press Delete and enter a new one.
To activate the connection code, restart the product.
If Grundfos GO Remote fails to connect and asks you to press OK or theRadio communication button on the product, the product has no
connection code or has a different connection code. In this case, press OK or the Radio communication button to establish connection.
6.39 "Run start-up guide"
The function is only available in the advanced operating panel.
The startup guide automatically starts when you start the product for the first time. You can always run the startup guide later. The startup
guide guides you through the general settings of the product.
To run the startup guide, go to Settings > General settings > Run start-up guide.
6.40 "Alarm log"
This function contains a list of logged alarms from the product. The log shows the alarm code, name of the alarm, when the alarm occurred
and when the alarm was reset.
6.41 "Warning log"
This function contains a list of logged warnings from the product. The log shows the warning code, name of the warning, when the warning
occurred and when the warning was reset.
6.42 "Assist"
This menu consists of a number of different assist functions.
Assist functions are small guides that take you through the steps needed to set the product.
6.43 "Assisted pump setup"
This function guides you through the following:
Setting the motor
•
Selection of control mode
•
Configuration of feedback sensors
•
Adjustment of the setpoint
•
Controller settings
•
Summary of settings.
With Grundfos GO Remote, access the Assisted pump setup menu.
With the advanced operating panel, access the Assisted pump setup menu.
6.44 "Setup, analog inputs"
The function is only available in the advanced operating panel.
•
Analog inputs, follow on-screen instructions.
•
Pt100/1000 inputs, follow on-screen instructions.
Related information
6.12 "Controller" ("Controller settings")
6.45 "Setting of date and time"
The function is only available in the advanced operating panel.
The inputs and outputs available depend on the functional module fitted in the motor.
56
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
