Polytron HDS 2 T/IP Bedienungsanleitung Seite 45

9.3 Menu "Configuration"
In the menu "Configuration" 5 selection buttons are provided, "Save", "Restore", "Factory Set", "Backup" and "Load".
"Save"
By pressing the "Save" button, all settings in the device are stored permanently.
NOTE If the button "Save" has not been pressed, all settings will be lost during a reboot or when the device is
switched off!
"Restore"
By pressing the "Restore" button, the last stored parameters are restored.
"Factory Set"
By pressing the button "Factory set", the device is reset to the factory settings and the default parameters are loaded.
"Backup"
By pressing the button "Backup" and via click on the button "Backup config", a backup file is stored on the PC/laptop.
"Load"
Select the backup file in the PC/laptop by clicking on the "Browse" button and activate the loading of the selected con-
figuration file onto the device by clicking the "Load config" button.
9.4 Menu "Firmware"
The "Firmware" menu allows the software update of the device, so the current components can be updated and new-
ly implemented functions can be activated. By clicking the "Browse" button, select the firmware update file on the
PC/laptop and start the update by clicking on the "Upgrade" button.
ATTENTION
Do not switch off the device during the update process. The update requires a longer update time since this is done for
several software components. Selecting an incorrect update file can cause malfunctions in/at the device.
45
Select function