Safety Notes; Installation Instructions; Technical Data; Symbol Description - HANSGROHE Showerpipe Crometta S 240 Reno EcoSmart 27795000 Gebrauchsanleitung, Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The arm of the shower head is intended only to hold
the shower head. Do not load it down with other
objects!
The product may only be used for bathing, hygienic
and body cleaning purposes.
Children as well as adults with physical, mental and/
or sensoric impairments must not use this product
without proper supervision. Persons under the
influence of alcohol or drugs are prohibited from
using this product.
Do not allow the streams of the shower touch
sensitive body parts (such as your eyes). An
adequate distance must be kept between the shower
and you.
The product may not be used as a holding handle. A
separate handle must be installed.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• During installation of the product by qualified trained
personnel, make sure that the entire fastening surface
is even and smooth (no protruding seams or tile
offset), that the finish of the wall is suitable to apply
the product and has no weak points.
• The premounted dirt collection screens must be used
to prevent dirt from entering through the pipes. Dirt
entering can affect the function and/or lead to
damage to the functional components of the fitting.
Hansgrohe will not be held liable for any resulting
damage.If necessary, the bottom end of the pipe can
be cut to length with a fine saw blade.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
4
max. 1 MPa
0,12 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
max. 70°C / 4 min
Assembly (see page 32)
English
• Safety against backflow
• The product is exclusively designed for drinking
water!

Symbol description

Do not use silicone containing acetic acid!
Dimensions (see page 35)
Flow diagram (see page 35)
Spare parts (see page 37)
Special accessories
order as an extra
tile-matching-disk #95239000 (see page 37)
Cleaning (see page 38)
Operation (see page 36)
Test certificate (see page 37)