Alarm Management - Palazzetti EASY TOUCH Verwendung Und Betrieb

6 ALARM MANAGEMENT

If a malfunction occurs, the following procedure is activated:
1) audible alarm (beep);
2) one of the following system LEDs come on:
3) if the problem concerns an error, the stove will switch o昀昀.
Pressing and holding the "cancel" button
ERROR/
WARNING CODE
E001
Faulty control panel
E002
Remote control signal communication error
E004
Communication error
E101
Failed ignition error
E105
Pellet probe malfunction
E108
*
Safety error
E109
Pressure error or thermal safety
E110
Temperature probe malfunction
E111
Flue gas temperature probe malfunction
Low pellet level (icon 昀氀ashing)
A001
Scheduled maintenance warning (icons
A002
昀氀ashing)
Pressure sensor malfunction (icon 昀氀ashing)
A007
----
Clean stove
----
Failed ignition error
* Only for the models equipped with safety microswitches on the door or on the hopper lid.
After having checked the type of message, the alarm can be reset by pressing the on/o昀昀 button
moments.
If the error code is "
stove (Fig. 6.1) ( this should be carried out by an authorized technician). Then the stove can be started again.
Before proceeding with a new ignition, check that:
the stove has cooled
•
the burning pot is clean and free of any ash residue or pellet
•
the burning pot is correctly positioned in its seat
•
the doors of the hearth and the tank are perfectly closed
•
shows the error code on the display:
DESCRIPTION
E109
", before resetting the alarm, manually reset the thermostat located on the rear of the
004776500 - 11/12/2019
;
POSSIBLE CAUSES
Control panel fault
Control panel fault
Connection cable between board and control panel
interrupted or detached.
If this appears when changing con昀椀guration, ignore
the error
No pellets
Pellet quality
Faulty ignition system
Burn pot dirty
Problems with the heating system
Problems with the pump
Pellet probe disconnected or faulty
Door or hopper lid open
Flue gas exhaust system dirty
Seal gaskets worn
Insu昀케cient combustion air
Problems with overheating in the pellet hopper
Faulty air temperature probe
Faulty 昀氀ue gas temperature probe
Pellets running out
The stove periodically requires maintenance to be
performed by a quali昀椀ed technician
Pressure sensor or board fault.
Combustion chamber, burn pot or 昀氀ue gas exhaust
system dirty.
Pressure measuring tubes detached or blocked.
Combustion air intake blocked.
No pellets; Faulty ignition heater; Worn gaskets;
Incorrect burn pot position
LED
for a few
- 6.1 -
27