Console; Program - VirtuFit Easy Fit Crosstrainer Bedienungsanleitung

ENGLISH
The hand sensors are not working properly: Wash your hands, dry
them well and test the hand sensors again. If this does not solve the
problem, check the handlebar cables for damage and ensure that they
are properly connected to the connector. If this still does not correct
the problem, replace the handlebar.
Console does not work: If there is no signal, check that the cable is
correctly connected.
CONSOLE (FIG. A)
• MIN (-) Druk op de "-" toets om de waarde van de geselecteerde
functie te verlagen. Druk tijdens een training op de "-" toets om
de weerstand te verlagen.
• START/STOP Start or stop the training.
• ENTER Press the "ENTER" button to confirm settings or switch
on from WATT to RPM and back.
RECOVERY Heart rate Recovery test.
•
• RESET Press the "RESET" button to erase all values. User-defined
U1-U4, WATT and PULSE are not cleared.
• MIN (-) Press the "-" key to decrease the value of the selected
function. During a workout, press the "-" key to decrease the
resistance.
PLUS (+) Press the "+" key to increase the value of the selected
•
function. During a workout, press the "+" key to increase the
§resistance.
• DISPLAY-ALT Press the "DISPLAY-ALT" key to fix a selected value.
Functions
• TIME The time measured from the start of the exercise is
displayed.
• SPEED The current speed during the exercise is displayed.
DISTANCE The distance covered during the exercise is displayed.
•
• CALORIES The number of calories burned during the exercise
is displayed.
• PULSE When placing the hands on two contact surfaces, the
heart rate can be measured. After 3 seconds, the most accurate
heart rate is displayed. This measurement cannot be taken as a
basis for medical treatment.
• RPM Revolutions per minute.
• WATT Displays the wattage.
• SCAN The different values are displayed alternately. Jumps
every 6 seconds.
LENGTH WEIGHT KPH RPM
CM KG KM/H R/MIN
PROGRAMS (FIG. B, 1-7)
Manual mode P1 (FIG. B-1)
• Press "START" or press "ENTER" in setting mode to start the
programme.
• In setting mode, press "ENTER" to set one of the following
values: TIME, DISTANCE, CALORIE, AGE. The selected value
flashes.
• Press "UP" or "DOWN" to adjust a value up or down. Press
"ENTER" to move to the next item.
• When all values are set, the screen automatically exits the
settings and starts the programme. Alternatively, "START" can
be pressed to start the programme.
• The resistance level can be adjusted at any time during the
programme by pressing "UP" or "DOWN".
• When one of the settings is set, the corresponding value is
counted down. If this value is at 0, a sound will go off.
• Press "STOP" to stop the programme.
Program mode P2-11 (FIG. B-2)
• Press "UP" or "DOWN" to select a specific function.
• Press "START" to start the programme or press "ENTER" to enter
the setting mode.
• In setting mode, press "ENTER" to set one of the following
values: TIME, DISTANCE, CALORIE, AGE. The selected value
flashes.
• Press "UP" or "DOWN" to adjust a value up or down and press
"ENTER" to move to the next item.
• When all values are set, the screen automatically exits the
settings and starts the programme. Alternatively, "START" can
be pressed to start the programme.
• The resistance level is automatically adjusted to the programme
level. During training, it can be adjusted manually by pressing
"UP" or DOWN".
• When one of the settings is set, the corresponding value is
DIST CAL WATT PULSE
KM KCAL W BPM
19