Maintenance; Maintenance Schedule - Husqvarna S 138i Bedienungsanweisung

6. Remove the battery from the battery charger.
Battery charging status
A Husqvarna Li-ion battery can be charged or used at
all charging levels. The battery is not damaged. A fully
charged battery will not decrease its charge when the
battery is left in the charger.
LED display
LED 1 flashes
LED 1 is lit, LED 2 flashes 25%-50%
LED 1, LED 2 are lit, LED
3 flashes
LED 1, LED 2, LED 3 are
lit, LED 4 flashes
LED 1, LED 2, LED 3,
LED 4 are lit
To operate S 138i
To start the product
1. Put a charged battery in battery compartment
number 1 below the battery lid. For longer operation
time, put a second charged battery in battery
compartment number 2.
2. Turn the safety key to 1. (Fig. 41)
3. Stay behind the product.
4. Press the ON/OFF button (A) on the control panel
and the green LED (B) comes on. (Fig. 42)
5. Loosen the start inhibitor. (Fig. 43)
6. Push the motor brake handle in the direction of the
handlebar. (Fig. 44)
To use the SavE function
The product has a battery saving function (SavE) that
gives longer operation time.
1. Press the SavE button (A) to start the function. The
green LED comes on. (Fig. 45)
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
937 - 006 - 05.10.2022
Charging status
0%-25%
50%-75%
75%-100%
Fully charged

Maintenance

Before you do
2. Press the SavE button again to stop the function.
The green LED (B) goes out.
To stop the product
The product stops automatically if you do not operate it
for 10 minutes. Always turn the safety key to 0 before
you let the product out of view.
1. Release the motor brake handle to stop the motor.
(Fig. 46)
2. Press the ON/OFF button (A) on the control panel
and the green LED (B) goes out. (Fig. 42)
3. Open the battery lid and turn the safety key to 0.
(Fig. 47)
4. To remove the battery, press the 2 release buttons
at the same time and pull out the battery. (Fig. 48)
5. Charge the battery if it is weak. For more
To charge the battery on page 20 .
information, see
To operate S 138C
To start the product
1. Connect a power cord to the socket below the
handle. (Fig. 49)
2. Put the power cord in the power cord holder. Refer
To use the power cord holder (model S 138C) on
to
page 16 . (Fig. 30)
3. Stay behind the product.
4. Loosen the start inhibitor. (Fig. 50)
5. Push the motor brake handle in the direction of the
handlebar. (Fig. 51)
To stop the product
1. Release the motor brake handle to stop the motor.
(Fig. 52)
2. Disconnect the power cord from the mains and then
from the product. (Fig. 53)
CAUTION:
out. Do not pull the power cord.
a service agent, speak to them for information about the
nearest service agent.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with *, refer to
on the product on page 15 .
Pull the plug straight
Safety devices
21