Maintenance; General; Maintenance Schedule; General Inspection - Husqvarna LC 348VI Classic Bedienungsanweisung

General

WARNING! The user must only carry out
!
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by an authorized service workshop.
Switch off the engine before carrying out
any checks or maintenance. Prevent
unintentional starting by removing the
ignition cable from the spark plug. The
starter key or battery must also be
removed on machines with electric start.
The life span of the machine can be
reduced and the risk of accidents can
increase if machine maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally.
If you need further information please
contact your nearest service workshop.
• Let your Husqvarna dealer regularly check the
machine and make essential adjustments and repairs.
• Replace any damaged, worn or broken parts.
• Always use genuine accessories.

Maintenance schedule

In the maintenance schedule you can see which parts of
your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated
based on daily use of the machine, and may differ
depending on the rate of usage.
Weekly
Daily
maintenan

maintenance

ce
General
Spark plug
inspection

Oil level

Muffler*
Vibration
External
damping
cleaning
system*
Cutting
equipment
Cutting cover
and protective
cover*
Engine brake
handle*
*See instructions in the section "Machine's safety
equipment".
MAINTENANCE
At least
50 hours once a
year
Replacing Replacing
and and
adjusting adjusting
the V-belt the V-belt
Air filter Air filter
Fuel Fuel
system system
Oil change Oil change

General inspection

• Check that nuts and screws are tight.

External cleaning

• Brush leaves, grass and the like off of the lawn mower.
• Do not use a high pressure washer to clean the
machine.
• Always remove the battery from the machine before
performing any maintenance, repairs or cleaning on
the machine. To remove the battery (main switch),
hold in the lock buttons and pull it to the side.
• Never flush water directly on the engine.
• Clean the air intake on the starter. Check the starter
and starter cord.
• When cleaning under the cutting cover, empty the fuel
tank and put the machine on its side with the muffler
down.
Cleaning of the gear housing.
• Remove the service hatch.
• Brush leaves and grass off of gear housing. If
necessary clean the gear housing with water.
Oil level
The lawn mower should stand on flat ground when you
check the oil level. Check the oil level with the dipstick on
the oil filler cap.
• Remove the oil cap and wipe the dipstick clean.
• Put the dipstick back in. The oil filler cap must be
completely screwed down to give a correct picture of
the oil level.
• If the oil level is low, fill using engine oil up to the upper
level on the dipstick.

Oil change

• Empty the fuel tank.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs
out through the filler pipe. Ask where you can dispose
of surplus engine oil at your local petrol station.
• Fill with new engine oil of a good quality. See
instructions in the section "Technical data".
–
English 81