Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Getting Started
1.
Attach all four castor wheels to the stainless steel base.
2.
Loosen the stand height adjustment knob and lift the dental control box to working height.
Tighten the stand height adjustment knob to secure.
3.
Screw on the high speed handpiece and low speed waste collection container under the
control panel, located behind the 3 way syringe grey cabling. (picture P.4)
4.
Fill the clear plastic water bottle at the back of the machine with distilled water and screw into
the holder with the blue tubing, Do not over tighten.
5.
Fill the amber plastic bottle with the CLS Concentrate Solution (8.5oz or 250 ml) and
dilute with distilled water (25.4oz or 750ml) to make a 33.82 oz or 1 litre solution. Screw the
bottle into the holder with the green tubing. Do not over tighten.
6.
Place the 3 way air/water syringe in its handpiece holder—center position.
7.
Connect the handpieces by screwing them to the grey handpiece line (see picture below) and
place in correct handpiece holder labeled on the dental system. Page 4 (D) and (I)
8.
Check the main dental machine air line (grey in colour) is connected to the quick disconnect
fitting on the compressor outlet tap (on/off) (See page 23)
9.
Plug the unit into an electrical outlet with power cord supplied and turn power board ON.
(see page 5)
iM3 Dental Systems
6
Werbung
Inhaltsverzeichnis
