Unitec EIM22-003 Bedienungsanleitung Seite 13

• Areas, such as kitchens, where combustion processes take place continuously.
• Areas with high humidity such as bathrooms, or near appliances such as dishwashers or washing machines.
7. Activation
Before you put the smoke alarm into operation, it is important to activate it and check that it is
working properly. There is a black switch on the back of the smoke alarm. Please switch this from
"OFF" to "ON" first before mounting or testing the smoke alarm.
• Press the test button and hold it for approx. 3 seconds until the LED indicator lights up. Release the
test button immediately afterwards. The smoke alarm will beep to indicate that it is activated.
• Test that the smoke alarm is correctly activated by pressing the test button. In the correct activation
mode, 3 beeps are heard and the LED flashes 3 times. If no sound is produced, the smoke alarm is
not properly activated and must not be used.
To protect your hearing, the volume of the first nine beeps is set to a "normal volume". Only then will
you hear a loud alarm signal.
8. Assembly
• Place the mounting plate at the
desired installation location and
mark the positions for the drill holes.
• Drill two holes with a diameter of 5
millimetres.
• Press the plastic dowels into the
holes.
• Place the screws in the mounting
plate and tighten them in the
dowels.
• Place the smoke alarm on the
mounting bracket and fix it by
rotating it clockwise.
• To fix the smoke alarm, insert the
fixing bolt into the hole between
the mounting plate and the smoke
alarm.
• Check that the smoke alarm is
functioning correctly by pressing
008153308321_30832_BDA_lang_sw_0722.indd 13 008153308321_30832_BDA_lang_sw_0722.indd 13
von der
dazu ggf. einen
Ceiling
Dowel
Mounting plate
Screws
Smoke Alarm
13
26.08.22 09:36 26.08.22 09:36