Troubleshooting - Clearaudio azimuth optimizer Bedienungsanleitung

User manual / Bedienungsanleitung
Follow these advises to adjust the azimuth:
measurement
L – R (Track 1)
R – L (Track 2)
L – R
R - L
L - R
R - L
Note:
The measurement values in the table are only used as examples and can be different depending on
the type of cartridge.

5. Troubleshooting

If you have a problem with your
incorrect operation.
If the error persists, please contact your dealer!
Never try to open the device and/or repair it yourself, this will void the warranty!
Error
Device does not work
No sound or
low volume?
Hum or
noise
Page / Seite 10
Left channel (display)
0
-30dB
0
-25dB
0
-35dB
azimuth optimizer
Cause
Is the power cord plugged in and the power
switch turned on?
Did you choose the right input?
Is the volume set too low?
The connection cables are not properly
connected.
Devices with a headphone output only:
Are the headphones still plugged in when
you are trying to play music through the
speakers?
The ground cable is not connected or is
faulty.
The device should not be operated in the
vicinity of high-frequency devices such as
mobile phones or modems or on power
supply systems used for data traffic (PLC).
Right channel (display) Direction of cartridge-
-30dB
0
-35dB
0
-25dB
0
, first check the possible causes to rule out
Check the connection.
Check the connections of your hifi
components.
Check the volume setting of your device.
Check the
connections due the their respective user
manual.
Disconnect the headphones.
Connect the grounding cable from the
turntable/tonearm
grounding connection on the back of
the device. If there are several ground
connections, interrupt them one after the
other and check the sound quality again.
Make sure there is a minimum distance of
30cm between the power supply units of
any type and the MC preamplifier or phono
preamplifier. Powerlan adapters should not
be operated on the same socket as the
phono preamplifier.
© clearaudio electronic GmbH, 2022-12
rotation
Azimuth is O.K.
Rotate cartridge
clockwise
Rotate cartridge
counter clockwise
Measure
tonearm and cartridge
to the respective