Menu 2: Light Function For The Hand Transmitter; Deleting All Hand Transmitters Programmed For The Drive - Novoferm N-423 Accu Bedienungsanleitung

4.10.3 Menu 2: Light function for the hand transmitter
D
A1
Fig. 9: Programming the light function for the hand transmitter
1. Briefly press the programming button (PROG button) (D) twice.
ð The display shows "2".
2. Press the button on the hand-held transmitter to control the light until the di-
gital point (A1) in the display flashes 4 times.
3. As soon as the light goes out, you can set the next hand transmitter (see
Step 1).
NOTICE
Up to 10 codes can be learned.
(Example: 5x start and 5x light).

4.10.4 Deleting all hand transmitters programmed for the drive

D
Fig. 10: Deleting all hand transmitters programmed for the drive
1. Disconnect the power supply by removing the cable between accumulator
pack and drive head.
2. Press and hold the oval programming button (PROG button) D.
3. Reinsert the cable between accumulator pack and drive head while you con-
tinue pressing the programming button (PROG button) D.
ð All hand transmitters programmed for the drive are deleted.
60 - EN