Mounting The Garage Door Drive; Disengage The Carriage - Novoferm N-423 Accu Bedienungsanleitung

4.5

Mounting the garage door drive

Follow the instructions as shown on the Instruction poster.
Step Installation
1 Fold out the rail (3 & 8) to its full length. Push the rail connector (7) centrally over the joints.
The chain or the toothed belt may have to be re-tensioned. See illustration.
2 Mount the centre suspension (13) to the guide rail. Mount the mounting brackets (18) on
the drive head (1).
3 Mount the connector attachment (11) to the garage door.
4 Mount the wall bracket (10).
5a Mount the guide rail (3 & 8) to the wall bracket (10).
5c/d Mount the ceiling mountings (16) to the centre bracket (13) and to the drive head (1). Then,
mount the ceiling mountings (16) to the ceiling.
6 Connect the linking bar (12) between the carriage (4) and the garage door connector
attachment (11).
7 For programming, open the cover of the drive head with a screwdriver or a similar tool.
8 Attach the warning sticker (19) to the inside of the garage door so that it is easily visible.

4.5.1 Disengage the carriage

NOTICE
The ball handle must be located 1.80 m max. above the floor.
During assembly, it may be necessary to disengage the carriage from the con-
nector attachment. This can be done without the need to disconnect the linking
bar.
III
Fig. 6: Disengaging and engaging the drive
54 - EN
II
I