Bosch PRIO Lithium-Ion Originalbetriebsanleitung Seite 33

OBJ_BUCH-28-003.book Page 33 Friday, December 18, 2009 2:34 PM
External Dust Extraction (see figure B)
When working without dust extraction, please plug the
outlet piece 8 with the dust protection cap 9.
When working with dust extraction, remove the dust pro-
tection cap 9. Insert the extraction adapter 10 into the
outlet piece 8. A suction hose with a diameter of 35 mm
can be connected to the extraction adapter 10.
The vacuum cleaner must be suitable for the material be-
ing worked.
When vacuuming dry dust that is especially detrimental to
health or carcinogenic, use a special vacuum cleaner.
Replacing the Sanding Sheet (see figure C)
When attaching a new sanding sheet, remove any dust or
debris from the sanding plate 4 (e. g. with a brush).
To ensure optimum dust extraction, pay attention that
the punched holes in the sanding sheet match with the
holes in the sanding plate.
The sanding plate 4 is fitted with Velcro backing for quick
and easy fastening of sanding sheets with Velcro adhe-
sion.
Before attaching the sanding sheet 3, free the Velcro
backing of the sanding plate 4 from any debris by tapping
against it in order to enable optimum adhesion.
The machine is fitted with 2 sanding sheets that can be
changed individually, depending on the degree of wear.
Only use the machine when both sanding sheets are
mounted.
Only use sanding sheets with the same grain size.
Position the sanding sheet 3 flush alongside one edge of
the sanding plate 4, then lay the sanding sheet onto the
sanding plate and press firmly.
To remove the sanding sheet 3, grasp it at one of the tips
and pull it off from the sanding plate 4.
Sanding sheets of the Bosch Delta Sander can be used.
Sanding accessories, such as fleece pads/polishing cloth
pads, are attached to the sanding plate in the same man-
ner.
Bosch Power Tools
English | 33
2 609 004 644 | (18.12.09)