Machine Information; Technical Specifications - VONROC IW504AC Originalbetriebsanleitung

Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• If the supply cord of this power tool is dam-
aged, it must be replaced by a specially pre-
pared supply cord available through the service
organization.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The machine is intended for driving in and loose-
ning screws and bolts as well as for tightening and
loosening nuts whilst adhering to the technical
data. Main purpose environment is in the automo-
tive sector, for metal construction or roofing work.
The device is not intended for drilling.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Protection class
No load speed
No load impact rate
Chuck
Max. torque
Weight
Sound pressure level LPA
Sound power level LWA
Vibration
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardized test given in EN 62841-1 and EN
62841-2-2; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
WWW.VONROC.COM
IW504AC
230-240V
50Hz
Class II
2300/min
0-3000/min
1/2" square chuck
600Nm
4.4 kg
88 dB(A) K=3 dB(A)
99 dB(A), K=3dB(A)
10.32 m/s² K=1.5 m/s²
applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
• The vibration and noise emissions during
actual use of the power tool can differ from
the declared values depending on the ways in
which the tool is used especially what kind of
workpiece is processed.
• Need to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such
as the times when the tool is switched off and
when it is running idle in addition to the trigger
time)
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Machine
2. Main handle
3. Power cable
4. Forward on / off switch
5. Reverse on / off switch
6. Metal enclosure
7. 1/2" (12,7 mm) square chuck
3. ASSEMBLY
Removing and mounting accessories
Use only 1/2" (12,7 mm) impact accesso-
ries. Non-impact accessories may break
and cause a hazardous condition. Inspect
accessory prior to use to ensure that it
contains no cracks.
• Turn off the machine
• Remove socket from chuck (7), if there is one.
• Click the new socket on the chuck (7).
• Check if the socket is properly attached.
• To remove the socket, simply pull it off.
EN
5