Installation; Rack Installation; Inserting A Battery Into The Remote Control - Omnitronic MPZ-Serie Bedienungsanleitung

5

INSTALLATION

Rack Installation

This amplifier is built for 483 mm racks (19"). This rack should be a double-door rack where front panel and
rear panel can be opened. The rack should be provided with a cooling fan. When mounting the amplifier into
the rack, please make sure that there is enough space around the device so that the heated air can be
passed on. Steady overheating will damage your device.
You can fix the amplifier with four screws M6 in the rack. If several devices are to be installed, make sure
that you leave 1 unit (1 U) space between the devices. Be careful when mounting the amplifier into the rack.
Put the heaviest devices into the lower part of the rack. Be aware that fastening the amplifier with four
screws on the front panel is not enough. In order to ensure safety, additional fastening by using ground and
side bars is necessary.
If racks are to be transported or used for mobile use, fasten the devices additionally by connecting the rear
brackets with the side or ground bars of the rack. Thus, the amplifier cannot be pushed backwards. The front
panel alone is not designed to absorb acceleration forces occurring during transportation.

Inserting a Battery Into the Remote Control

1
The remote control of the audio player is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during storage. Prior to the
first operation remove the foil from the battery support on the rear side of the remote control. Otherwise
operation of the remote control is not possible.
If the range of the remote control decreases (3 meters as a maximum),
replace the battery. For this purpose, on the rear side of the remote control
press the small bar with the groove to the right and at the same time remove
the battery support.
2
If the device is not used for a longer period (approx. 1-2 weeks), please remove the battery to prevent
damage in case of battery leakage.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and
should not be disposed of with regular domestic waste!
CAUTION!
23