Line Output; Microphones; Units With Line Level; Connection With The Mains - Omnitronic MPZ-Serie Bedienungsanleitung

Example for the calculation number of speakers/impedance
Number of speakers
speaker at
1 8 Ω
speakers at
2 8 Ω each 4 Ω (parallel)
speakers at
8 Ω each 16 Ω (in line)
2
speakers at
3 8 Ω each 2.66 Ω (parallel)
speakers at
3 8 Ω each 24 Ω (in line)
speakers at 8 Ω each 2 Ω (parallel)
4
The input impedance of the speaker systems should at least be the same or even higher than the output
impedance of the amplifier.
Information on choosing appropriate speaker cables
• Speaker systems must only be connected via sufficiently dimensioned cables. Too thin cables lead to cable
heatup or enormous power loss and loss in sound quality.
• For all speaker systems up to 400 Watts, we recommend a cable diameter of 2.5 mm², for all other speaker
cables 4 mm².
• A high damping factor of your amplifier supplies a clear sound reproduction. Unnecessarily long and thin cables
will influence the damping factor and thus the low frequencies in a negative way. In order to safeguard good
sound quality, the damping factor should lie around 50. The longer a cable has to be, the thicker it should be. In
this respect, a damping factor of 200 will be reduced to 47 (8 ohms) when using a 10 m long, 2.5 mm² speaker
cable. The power loss at 8 ohms is 1.63 %, at 4 ohms 3.25 % and at 2 ohms even 6.5 %.
• The maximum cable length is 30 meters.

Line Output

For connection to units with line level (e.g. mixer, amplifier) the stereo RCA output [LINE OUTPUT] can be
used.

Microphones

Three unbalanced inputs are available for connecting dynamic microphones: two via 6.3 mm plug at the rear
inputs [MIC 2 INPUT] and [MIC 3 INPUT], and one via XLR or 6.3 mm plug at the front combo input
[PRIORITY MIC 1]. The XLR jack is equipped with a lock which is released by pressing the PUSH lever
down and pulling the microphone plug out at the same time. Input [PRIORITY MIC 1] features an adjustable
priority function.

Units with Line Level

Three audio units with line level can be connected to the stereo RCA inputs [LINE 1] to [3].

Connection with the Mains

Finally connect the device to a mains outlet (230 V AC, 50 Hz ~) with the mains cable.
The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected! If the device will be directly connected with the local power supply network, a
disconnection switch with a minimum opening of 3 mm at every pole has to be included in the permanent electrical
installation. The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current
of 30 mA
≙ ≙ ≙ ≙ Impedance
8 Ω
International
L
N
25