SunTech Tango+ STRESS BP Gebrauchsanweisung Seite 34

34
Guidance and manufacturer's declaration – electromagnetic emissions
The Tango+ Monitor is intended for use in the electromagnetic environment
specified below. The customer or the user of the Tango+ Monitor should assure
that it is used in such an environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-1
Power
frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE: U is the a.c. mains voltage prior to application of the test level
T
In the event of a power loss to the monitor, all data and user settings are saved. The
monitor will power-up with the same settings and data as prior to the power loss.
IEC 60601 Compliance
test level
±6 kV contact
±8 kV air
±2 kV for power supply
lines
±1 kV for input/output
lines
±1 kV differential mode
±2 kV common mode
<5 % U (>95 % dip in U
T
for 0,5 cycle
40 % U (60 % dip in U
T
for 5 cycles
70 % U (30 % dip in U
T
for 25 cycles
<5 % U (>95 % dip in U
T
for 5 sec
3 A/m
Electromagnetic environment-
level
Floors should be wood, concrete or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30 %.
Mains power quality should be that
of a typical commercial or hospital
environment.
)
T
Mains power quality should be that
of a typical commercial or hospital
) environment. If the user of the
T
Tango+ Monitor requires continued
operation during power mains
) interruptions, it is recommended that
T
the Tango+ Monitor be powered
from an uninterruptible power
) supply or a battery.
T
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital environment.
guidance