Main Menu Selections And Settings; Monitor Setup - SunTech Tango+ STRESS BP Gebrauchsanweisung

Main Menu Selections and Settings

Press the Select key to access the MAIN MENU. Press the UP/DOWN keys to
navigate through the MAIN MENU and then press the SELECT key to confirm your
choice. To exit out of the MAIN MENU, select EXIT and you will return to the Main
Measurement View.

Monitor Setup

Use to set up and maintain the monitor.
Stress System:
Language:
Time:
Contrast:
Verify
Calibration:
Power Off After:
MAIN MENU
MONITOR SETUP
MEASUREMENT SETUP
VIEW
ALARMS
MEASUREMENT TABLE
END TEST
EXIT
Select your stress system model that will interface to the
Tango+. For a custom model, select CUSTOM and then
choose the correct protocol and type of ECG trigger.
If you are using the Internal ECG option, you must select
CUSTOM and then set the ECG Trigger to INTERNAL.
Choose English, French, German, Italian, or Spanish
Set this to the current time. Defaults as 00:00.
Set monitor contrast for optimum display from
0–255 where 0 is darkest and 255 is lightest.
Displays cuff pressure for verifying calibration of the monitor.
Press the Select Key to quit.
Set the time after which the monitor turns off after no activity.
Set it to 10 minutes, 30 minutes, or Never.
If Tango+ is attached to a stress system, the Tango+ turns on
and off along with the stress system. However, you can turn the
monitor on yourself by pressing any key. If you turn it on, the
monitor will turn off after the time selected in this setting.
15