SunTech Tango+ STRESS BP Gebrauchsanweisung Seite 29

Cleaning
Monitor
Before cleaning, disconnect the power supply from the monitor. Wipe the device with
a soft, damp cloth to remove surface dust and dirt.
CAUTION: The Tango+ is not sterilizable. Do not immerse the monitor in
any fluid or attempt to clean with any liquid detergents, cleaning agents, or
solvents.
Cuffs
Use a mild medical grade disinfectant on the cuff sleeve and inside of the cuff
between patients. Periodically, remove the bladder, machine wash the shell of the cuff
in cold water and line dry.
ECG Cables
For routine cleaning, use a soft cloth to apply a mild soap and water mixture. Remove
any residue and wipe dry. For disinfecting the cables, use a hospital-approved
disinfectant such as 1:10 chlorine bleach, Lysolbrand disinfectant, 2% glutaraldehyde
solution, or Wescodyne. If disinfectants are intended to control infection, use your
facility's established protocol. For sterilizing, use your facility's established protocol.
Do not use the following methods for sterilization: autoclave, radiation, or steam.
When necessary, cables and leads can be sterilized in ethylene oxide (ETO) gas.
SpO Sensors
2
Clean the sensor with a soft cloth dampened with a mild detergent or isopropyl
alcohol. Ensure that all tape residues are removed. Allow the sensor to dry
thoroughly before reusing.
CAUTION: Never immerse sensors and clips in fluids. Do not pour or
spray any liquids onto the sensor. Caustic or abrasive cleaners will cause
permanent damage.
NOTE: Do not open the case of the adult finger clip sensor more than 90°
or the case may be damaged. Figure 11 shows the appropriate opening of
the case for cleaning.
Figure 11
29