Power Supply, Fuse And Phantom Power - Omnitronic LMC-1422FX Bedienungsanleitung

Operating Elements and Connections

Power supply, fuse and phantom power

All models
Fig. 4.26 Power supply, fuse and phantom power
Power input and fuse holder
The console is connected to the mains via the cable
supplied, which meets the required safety standards.
Blown fuses must only be replaced by fuses of the same
type and rating. The mains connection is made via a
cable with IEC mains connector. An appropriate mains
cable is supplied with the equipment.
Power switch
Use the POWER switch to turn on the mixing console.
The POWER switch should always be in the "Off"
position when you are about to connect your unit to the
mains.
PHANTOM switch
The PHANTOM switch activates the phantom power
(necessary to operate condenser microphones) on the
XLR sockets of the mono channels. The red +48 V LED
illuminates when phantom power is on. As a rule,
dynamic microphones can still be used with phantom
power, provided that they are wired in a balanced
configuration.
If the phantom power is switched on, no
Caution!
microphones with unbalanced
connected. Otherwise these microphones may be
damaged. During the stabilization phase (approx. 1
minute), you must not change any connection.
To prevent switching
PHANTOM switch when the mixer is switched off or
when the output level controls are set to minimum.
output must
noise, only actuate the
be
38