Turning On - Paj GPS EHICLE FINDER 4G 1.0 Bedienungsanleitung

NOTE!
When connected to the power supply, the Vehicle
Finder 1.0 switches on immediately and the LED lights
emit a signal. If the FINDER is not connected to the ve-
hicle battery, but at a different point (e.g. fuse box), this
can result in the ignition on / off function not being accu-
rately recognized.
-
+
ATTENTION!
The poles must never be reversed.

2.6 Turning on

After a successful activation you can switch on the
VEHICLE Finder 1.0. By connecting the FINDER to the power
supplythe device has already been switched on.
It is recommended to start VEHICLE Finder 1.0 for the
first time in places where the vehicle is not covered
(not in the garage or similar).
Black cable
-
Battery
9-75 V
+
Red cable
25