Connection Inside The Vehicle; Turning On - Paj GPS CAR FINDER Bedienungsanleitung

To do this, please go to
www.start.finder-portal.com
and follow the instructions.

2.5 Connection inside the vehicle

The following points must be observed by all means
The CAR Finder should not be installed near fuel
lines or other combustible components in the
engine compartment.
When mounting the CAR Finder, please make sure
that no other components in the vehicle are
damaged.
Installing the CAR Finder may discharge your
vehicle battery. Before connecting, check whether
your vehicle has a discharge protection and
retrofit it if necessary.
Please always observe the manufacturer's
specifications for your vehicle. Compensation
claims due to incorrect connections are hereby
excluded
Connect the CAR Finder to the appropriate socket in
your vehicle using the OBD interface. Please make
sure that the CAR Finder is inserted deep enough. You
can tell if the FINDER has been plugged in deep
enough when the device is off (switch to "off") and the
LEDs start flashing.
The OBD interface has no standardized position in
the vehicle. The user manual of your vehicle can

2.6 Turning on

Once the activation, switching on and the transfer of
a first database has been successful, you can switch
on the CAR Finder. By connecting the FINDER to the
power supply, which was previously carried out, it has
already been switched on.
However, leave the switch set to "on" so that in the
event of theft, if the FINDER is disconnected from the
OBD interface, data can still be transmitted.
For the initial startup of the CAR Finder uncovered
locations, such as the garden or the terrace (i. e.
not inside the home, the garage, the cellar or the
CAR Finder by PAJ with Online-Tracking V.1.1 EN
© PAJ UG (haftungsbeschränkt)
17
provide you with this information
like) are recommended.