Activation; Turning On; Use - Paj GPS ASSET Finder 4G Bedienungsanleitung

The ASSET Finder 4G offers you a running time of approx.
180 days without charging! However, it should be noted that
the duration depends on the load. The more PAJ's ASSET
Finder 4G is moved and the more alerts are sent, the higher
the utilization.

2.4 Activation

Note: To activate you need the device ID. Please make a note
before installing your FINDER.
To use the ASSET Finder 4G by PAJ it must be activated online
first.
Please go to
www.start.finder-portal.com
and follow the instructions.

2.5 Turning on

Once the activation has been successful, you can switch on the
FINDER. The button with the on / off button is used to switch the
FINDER on and off. To do this, press this button for at least 5
seconds. The FINDER gives feedback through a vibration by
switching on and off. When the FINDER is switched off, the LEDs
continue to shine for approx. 1-2 minutes to transmit a last
position.
Recommended first step: To receive the best GPS signal
place the ASSET Finder 4G outside and make sure it is not
covered. Avoid garages, basements and similar.

2.6 Use

Once the activation, switching on and the transfer of a first
database has been successful, you can place the FINDER in a
location of your choice and take a look at the FINDER´s location
ASSET Finder 4G by PAJ with Online-Tracking V.1.0 EN
© PAJ UG (haftungsbeschränkt)
18