Symbols; Technical Data; Prescribed Usage - Protool Rgp 130-16 E Original Bedienungsanleitung

Reinstating grinder
RGP 130-16 E
Table of contents
1 Symbols ................................... 13
2 Technical data ........................... 13
3 Prescribed usage ........................ 13
4 Control Elements ....................... 14
5 Notes on Safety Prevention ......... 14
5.1 General Safety Instructions ......... 14
5.2 Safety instructions for all
working activities ....................... 14
5.3 Additional safety instructions
for all types of works .................. 15
5.4 Supplementary safety instructions
for grinding and cutting .............. 16
5.5 Additional safety instructions
for surface grinding .................... 16
5.6 Additional safety instructions
for grinding with wire brush ......... 16
5.7 Turner safety instructions ............ 16
5.8 Noise / Vibration Information ........ 17
6 Activation ................................. 17
6.1 Switching on - off ....................... 17
6.2 Regulation electronics ................. 17
7 Operation ................................. 18
7.1 Fastening the grinding wheel ....... 18
7.2 Positioning the handle................. 18
7.3 Dust suction .............................. 18
7.4 Lifting the front brush ................. 18
7.5 Brush replacement ..................... 18
7.6 Grinding wheel .......................... 18
8 Maintenance .............................. 18
9 Environmental Protection /
Disposal.................................... 19
10 Warranty .................................. 19
11 Declaration of Conformity ............ 19
12 The table with recommended
types of grinding wheels ............. 20
GB
1

Symbols

Double insulation
Warning of general danger
Risk of electric shock
Use protective goggles!
Wear ear protection!
Use protective gloves!
Read the instructions
Not to be included in municipal refuse
Advice or tip
►
2

Technical data

Nominal voltage
Mains frequency
Power input
Adjustable rpm
Tool
Weight
Protection class
3

Prescribed usage

The machine is designed for straighten-
ing concrete surfaces, smooth transfers
on boarding, removing plaster, paint, glue
residues, coating, corrosion, and for clean-
ing concrete and wooden surfaces.
The machine is constructed for use with
special wheels recommended by the manu-
facturer and they must not be used with a
wheel made from connected abrasive ma-
terial.
The machine can only be used for dry grind-
ing using an effi cient suction device.
Noncompliant use of the machine is a sole
responsibility of the user.
230 V ~
50 / 60 Hz
1600 W
3000 - 7700 min
-1
130 mm
3.8 kg
II /
13