auna iTuner CD Bedienungsanleitung Seite 54

EN
54
Push button
If your router has a WPS button you will notice [WPS] at the front of your
network name.
1. Press the
button to confirm.
2. You will now see a message on the screen telling you to press the WPS
button on your router. Press the WPS button on your router. Check your
routers instruction manual if you are unsure which button is the WPS
button.
3. Press the SELECT button to confirm. Your radio will now connect to your
router, this may take a few seconds.
Pin (code number)
The radio generates an 8-digit code number. Enter this code number into
the wireless router or access device.
Connecting using your wireless network password
If your router has not got a WPS button you will now be asked to enter your
wireless network password, or you can select SKIP WPS which also take you
to the password screen.
1. Press buttons to select each letter/number of your
password. Then press SELECT button to enter the selected letter/
number.
2. When you have entered your password, press
select OK on the right of the screen.
3. After your radio has connected, press SELECT button to exit the setup.
Settings can be changed at any time in Menu-System Settings - Network -
Network wizard: This instruction manual explains the basic instruction for
operating this unit. Unless otherwise stated, all operations described are
based on remote control use.
buttons to select Push Button, then press SELECT
buttons to