Storage, Cleaning - Crivit 388686 2107 Gebrauchsanweisung

• Make sure that the product, especially when
inflated, does not come into contact with
stones, gravel, or sharp objects and does not
rub or scrape against anything as this can
cause damage to the plastic foil.
• Use only the correct pump adapters to insert
into the safety valves. The valves might other-
wise be damaged.
• Do not over-inflate because you then risk tear-
ing open the welded seams. Close the valves
properly after inflating.
• Avoid contact with sharp-edged, hot, pointed
or dangerous objects.
Assembly
The product should always be assem-
bled by an adult. Please follow the
individual assembly steps in the order
indicated.
Inflation
WARNING!
• Always inflate the air chambers fully!
• Follow the correct sequence when
inflating the air chambers.
• Avoid inflating the air chambers too
much because there is the risk of
over-stretching the welded seams or
even tearing them open.
• Use standard commercial foot pumps
or double-stroke piston pumps with
matching adapter attachments to
inflate the product.
• Do not use a compressor or com-
pressed air bottles to inflate the
product. This can lead to damage to
the product.
• Make sure that the chambers are
filled with air uniformly.
• Inflate each air chamber until it feels
firm to the touch. When you press
with your thumb against the air cham-
ber it should still give a little.
Assemble in the following order:
1. Lower air chamber of the water polo goal
2. Upper air chamber of the water polo goal
3. Air chamber, basketball hoop
4. Balls
Proceed as follows to inflate:
1. Open the valve seal (1a) (fig. D).
2. Squeeze the valve stem (1b) together and
inflate the air chamber until the product is
sufficiently firm.
3. Close the valve seal and push in the valve by
pressing lightly (fig. D).
Water polo goal: Stand the product on a firm
surface and follow the assembly steps in figs.
B-C.
Disassembly
Water polo goal: Untie the knots on the net
and pull it out of the product hole by hole.
Deflation
1. Pull the valve out and open it.
2. Squeeze the valve stem together lightly so
that the air can escape or insert the deflation
tube into the valve to allow the air to escape
rapidly.
Repairs
Minor cracks or holes can be repaired with the
repair patch supplied.
Important! Do not inflate the product
for 20 minutes after repair! Do not use
the patch for cracks or holes on the
seam.
1. Let the air out of the product completely.
2. Clean the area around the leak thoroughly.
The area must be dry and free from grease.
3. Cut out a piece of the repair material that is
big enough for its edges to overlap the dam-
aged area by about 1.3cm.
4. Peel the patch off the paper, place it on the
damaged area and press tight.

Storage, cleaning

When not in use, always store the product clean,
dry, and not inflated at room temperature.
The valves should always be closed during stor-
age. When storing for the winter do not place
any sharp objects on the product and do not
apply talcum powder.
Only clean the product with a damp cloth and
wipe dry afterwards.
GB/IE/NI 5