General Maintenance - Qwic MIRA Bedienungsanleitung

info
If your bike has a belt drive, do not grease the belt. It is intended to run without any grease.
Instead, clean your belt regularly with lukewarm water.
Please find below some quick tips and tricks to maintain your e-bike:
>> Take care that there will be no dirt in between the motion sensor and the rotating part.
You can clean it with water and a sponge when dirty.
>> Check the tire tension and tire profile.
>> Check for wear and tear on the brakes and brake pads, replace or adjust them if needed.
>> Check the spoke tension, visit your dealer when you notice that spokes are bend or the wheel
is damaged.
>> Maintain all rotating and (electrical) connection parts with acid-free Vaseline (spray).

6.2. General maintenance

You can always contact your dealer for urgent repairs to the e-bike. To keep your bike in optimal
condition, it has to be checked regularly by your dealer. Preventive maintenance avoids possibly
larger repairs later. Because the amount of maintenance depends on how intensively the bike
is used, you must agree with your dealer on a suitable maintenance program.
The below maintenance program is an advice from QWIC under normal use.
Service frequency:
1st turn; 2 months / <500km
2nd turn; 6 months (Small service) (or every 1000km)
3rd turn; 12 months (Major service) (or every 2000km)
Then every six months 1 small service, 1 major service until the end of use.
Mira
28
6. TAKE CARE OF YOUR E-BIKE