Belt Drive; Rear Carrier - Qwic MIRA Bedienungsanleitung

5.5. Belt drive

The Mira Tour version is equipped with a belt drive. A belt drive is ideal
for QWIC powerful e-bike motors. The belt is silent in use and very
maintenance-friendly because the tension is retained longer. A properly
installed belt can be used for up to 25,000 km without having to be
replaced.
Maintenance
As you do not need to lubricate a belt, it is a lot cleaner compared to
a chain. As a result, no chain guard is needed when using a belt drive.
If needed, you can clean the belt with water. Do not use a high-pressure
cleaner, as this could cause damage to other parts of the bicycle.
Belt tension
Proper belt tension is key to optimal performance. If the belt is too tight,
it can cause drag and damage the hub. If the belt is too loose it can skip
teeth and slip. If you notice either of these, the belt tension should be
adjusted. Contact your dealer to get your belt checked.
bell
In case any teeth are broken from the belt, please contact your dealer directly.
bell
It is important to properly align the belt. If the alignment is not perfect,
the belt will wear down more quickly and cause noise. A belt cannot be pried
or pushed of the chainwheel like regular chains. Only let an accredited
dealer service your belt drive.

5.6. Rear carrier

Your QWIC Mira e-bike is equipped with a specially developed rear carrier.
This carrier is approved for a load of 27 kg and can easily be combined with
most bicycle bags, baskets and child seats thanks to the integrated MIK-HD
system. Ask your dealer for an overview of the available products or visit
www.mik-click.com
5. COMPONENTS
5.6. Rear carrier
27
25
kg
kg
Mira
25