Cleaning And Maintenance - Dometic ROOFTOP TRT140 AIR Awning Low Montageanleitung

By following this process before first use, will
ensure that the product weatherproofing will
improve with subsequent soakings.
Setting up the awning tent
!
CAUTION! Risk of injury and
material damage
• Do not use any type of compressor
designed to inflate car tires.
• Only inflate the air poles up to a maxi-
mum pressure of 9psi/0.62bar.
I
NOTE
• The awning tent comes with heavy
duty pegs. These will be suitable for
many sites but for some types of
ground special pegs will be needed.
Ask your dealer.
• Drive the pegs at a 45° angle away
from the awning tent into the ground.
• Peg each guy line in-line with the seam
it starts from.
Keep the following tips in mind while setting up the
awning tent:
• The figures provide a general overview of the
set-up. The actual set-up will vary slightly based
on the model of awning tent.
• Get help. The set-up is easier with more people.
• After standing the awning tent upright, check
the corner pegs and re-peg if necessary. The
groundsheet on the inside should be taut and in
a rectangular shape.
• Peg the guy lines so that the awning tent is under
tension without distorting the shape.
• If available, attach the storm straps.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
Set up the awning tent as follows:
1. To protect the awning tent from dirt and dam-
age, lay down a groundsheet or footprint
before unpacking.
2. Unpack the awning tent.
3. Separate and identify the different compo-
nents.
4. To set up the awning tent proceed as shown
(fig. 3, page 3 – fig. a, page 6).
Dismantling the awning tent
A
NOTICE! Damage hazard
Do not use force when dismantling the
awning tent. Otherwise you might dam-
age any material.
1. Remove any dirt on the outside.
2. If the awning tent is wet or damp, dry thor-
oughly.
3. Remove all lines and straps.
4. Remove all pegs.
5. Close all zippers.
6. Open the valve on the air pole.
7. Wait until most of the air has been expelled.
8. Carefully detach the awning tent from the
extrusion channel.
9. Open the buckles to detach the awning tent
from the rooftop tent.
10. Fold or roll the awning tent towards the valve
to expel more air.
11. When deflated, roll the awning tent to fit into
the carry bag.
12. Ensure that all parts are clean before packing
them into the carry bag.
Storing the awning tent
1. Clean the awning tent.
2. Air fully and ensure the awning tent is totally
dry before packing away.
3. Store in a well ventilated dry place.

Cleaning and maintenance

A
NOTICE! Material damage
• Do not use sharp or hard objects or
• Do not use alcohol based materials,
4445103840
cleaning agents for cleaning.
chemicals, soap and detergents for
cleaning.
9