Waeco CoolAir CA8505 Bedienungsanleitung Seite 31

CoolAir
6.5 Extracting condensation (SP950 only)
The condensated water which accumulates due to the way the system works
is automatically extracted at intervals during operation.
You can pump out the condensated water manually when necessary:
➤ Switch off the system.
➤ Press and hold the Operating mode (fig. 2 4, page 3) and – (fig. 2 7,
page 3) buttons simultaneously.
➤ In addition, press the ON/OFF button (fig. 2 1, page 3) briefly.
✓ The firmware version appears in the digital display for 5 seconds.
✓ 000 then appears in the digital display and the system starts the extraction
process for 15 seconds.
You can now let go of the Operating mode (fig. 2 4, page 3) and –
(fig. 2 7, page 3) buttons.
✓ The compressor and the fan do not switch on.
✓ The system switches off automatically.
Note
I
To stop the extraction early press the ON/OFF button until the
pump switches off.
Avoid pumping out the water too many times in succession. The pump can
be damaged if it runs dry (indicated by loud noise during extraction).
6.6 Switching off the stationary air conditioner
➤ With the system switched off, press the ON/OFF button (fig. 2 1,
page 3).
✓ The LEDs and digital display go out.
✓ The fan and the compressor switch off.
Using the stationary air conditioner
31