1. Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Noncompliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the noncompliance of the electric regu
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating instruc
tions before installing and commissioning the device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord
ance with the recommendations.
The operating instructions contain important informa
tion on how to operate the machine safely, profes
sionally and economically, how to avoid danger, cost
ly repairs, reduce downtimes and how to increase
reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regu
lations that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information. The machine can only
be operated by persons who were instructed con
cerning the operation of the machine and who are in
formed about the associated dangers. The minimum
age requirement must be complied with.
In addition to the safety instructions contained in this op
erating manual and the specific regulations of your coun
try, the technical rules generally accepted for the oper
ation of machines of the same type must be observed.
10 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
We accept no liability for damage or accidents which
arise due to nonobservance of these instructions
and the safety information.
2. Layout (Fig. 1)
1. Battery
2. Contacts
3. Battery release button
3. Safety notices for Li-Ion batteries
m WARNING! Read all safety directions and in-
structions.
Omissions in the compliance with safety directions
and instructions can cause electrical shock, fire and/
or severe injuries. Retain all safety directions and in
structions for future use.
• Do not open the battery. Risk of short-circuiting!
• Protect the battery from heat, e.g. from con-
stant sun exposure, and from fire, water and
humidity. Risk of explosion.
• When the battery has been damaged or it is
being used inappropriately, fumes can be re-
leased. Let fresh air in and consult a doctor if the
fumes cause you any problems. The fumes can ir
ritate the respiratory tract.
• If used incorrectly, liquid may leak from the bat-
tery. Avoid contact with this. In the event of acci-
dental contact, rinse off with water. If the liquid
gets into eyes, seek medical assistance. Leaking
battery fluid may cause skin irritations or burns
• Only use original batteries with the voltage
specified on the rating plate of your power tool.
If other batteries are used, e.g. imitations, recondi
tioned batteries or products from third party manu
facturers, there is a risk of personal injury as well
as property damage based on exploding batteries.
• The battery voltage must correspond with the
battery charging voltage of the charger. Other-
wise, there is a risk of fire and explosion.
• Charge the batteries only in chargers that have
been recommended by the manufacturer. There
is a risk of fire if a charger for a particular type of
battery is used for another type of battery.
• The battery can be damaged by sharp objects
such as a nail or screwdriver or by external ap-
plication of force. The battery may short-circuit and
start burning, smoking, exploding or overheating.
Warning!
This electric tool generates an electromagnetic field
during operation. This field can impair active or pas
sive medical implants under certain conditions. In or
der to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the electric tool.