Product Description - Concept SM 3000 Bedienungsanleitung

EN
• Turn off the product and disconnect the plug from the mains outlet before installing accessories,
performing maintenance, or in the case of any failure.
• Do not touch the moving parts during operation of the unit. Wait until it stops completely.
• The appliance is intended for domestic use only, not for commercial use.
• Do not immerse the power cord, plug, or appliance in water or any other liquid.
• Check the appliance and power cord for damage regularly. Never switch on a damaged appliance.
• Prevent loose hair and garments from hanging close to the openings and moving parts of the appliance.
• Before plugging the unit in or unplugging it from the wall outlet, make sure the switch is OFF.
• Always take extra care when handling the blades and slicers. They are very sharp and could cause an injury.
• Turn the unit off, disconnect the power cord from the wall outlet, and allow the unit to cool before
cleaning.
• The unit contains sharp parts. Extra care should be taken while cleaning the unit.
• Do not let the power cord hang loosely over the edge of the work area. Make sure the power cord does
not touch hot surfaces.
• Do not let the unit hang loosely on the power cord.
• Do not use the unit without correctly mounted accessories.
• Do not let the appliance run when empty.
• Do not repair the appliance yourself. Refer to an authorised service centre instead.
• This appliance may be used by children 8 years of age and older and by persons with physical or mental
impairments or by inexperienced persons if they are properly supervised or have been informed about
how to use of the product in a safe manner and understand the potential dangers. Children must not play
with the appliance. This appliance may be cleaned by children 8 years of age and older if they are properly
supervised. Keep this appliance and the power cord out of reach of children younger than 8 years of age
Failure to follow the manufacturer's instructions may lead to refusal of warranty repair.

PRODUCT DESCRIPTION

1 Small cup
2 Seal belt of lid
3
Jar
4
Blades
5
Jar base
6
Jar lid with handle
7 Soft touch Jar handle
8 Motor Driver Gear
9 Blender Motor Base
10 Shock-proof Suit
11 Safe switch bar
12 Stepless Speed control knob
13 Mode control button
14 "P" Mode
15 "Crusher" Mode
16 "Smooth blending" Mode
34
1
2
3
4
5
Intelligent switch
This blender owns "Mode", "0/Off", "Stepless Speed" 3 type SWITCH controls. You
could choose one of them for your drink / food processing.
"0/Off" switch controls
This speed control is to stop the blender or reset the blender speed.
Important: Machine only could be work when the switch knob is started from "O/
off" position.
"Mode" switch controls
Turn to this switch control position, 3 pcs Mode control buttons will be flashing.
Press "Ice Crusher" Mode or "Smooth blending" Mode, the chosen button will be
under long light and other buttons with no light. The machine will working as
setting.
Press the same button again, this button function will be canceled and all 3 buttons
will be back to flashing.
"P" Mode will stop at once when your finger leave from button
"P" Mode – Pulse function
Need to press it during blending, once your finger leave from button, this function will stop.
"Crusher" Mode – Crusher function
Blender under this mode will automatically work: few seconds on and stop, and repeat processing for several
time. Ice crushed under this mode will not spray and stick onto the glass jar wall
"Smooth blending" Mode – Crusher function
Blender under this mode will automatically work: speed moves faster and faster till to max speed, working 2
minutes will stop by itself.
SM 3000 SM 3000
6
8
7
9
14 15 16
EN
10
11
12
13
35