Device Description; Application - Beurer MP 64 Gebrauchsanweisung

4. DEVICE DESCRIPTION

The associated drawings are shown on page 3.
Manicure/pedicure device
1
Speed setting display
3
Sliding switch for clockwi-
5
se/anti-clockwise rotation
and off position
Storage bag
7

5. APPLICATION

• Charge the device for approximately 3 hours before the first use.
• When the 3 blue charger indicator lights flash continuously, it
means the battery is charging. Once all 3 LEDs are permanently
illuminated, the device is fully charged. You can now begin using
the device on battery power.
• If the blue LEDs flash quickly (1, 2 or 3 LEDs depending on the
speed setting) during battery operation, this indicates that the
battery is dead.
• You can charge the device by plugging it into the mains, or alter-
natively using the USB cable.
• One charge is sufficient for approx. 2 hours of cordless opera-
tion.
• Make sure that the device is switched off beforehand.
• Select the desired attachment part and carefully press it onto the
axle of the device. To remove, pull apart the attachment and the
device in opposing directions.
• Switch on the device by moving the sliding switch down (anti-
clockwise rotation, LED lights up red) or up (clockwise rotation,
LED lights up green).
+/- speed regulation
2
LED display for direction
4
of rotation (red for anti-
clockwise rotation; green for
clockwise rotation)
LED light
6
26