Beurer MP 64 Gebrauchsanweisung Seite 27

• You can select the speed of the drive axle using the plus (+) and
minus (-) buttons. Start each application at a low speed and then
increase as required.
• Blue LEDs light up on the surface of the device depending on
the selected speed.
• All filing and callus attachments are coated with a sapphire grain.
This guarantees a long service life and ensures practically no
wear.
• Do not press too hard and always carefully move the attach-
ments towards the area to be treated.
• Move the device over the area to be treated and apply slight
pressure while slowly moving the device in circles.
• Please note that the callus attachments show reduced perfor-
mance on soaked or wet skin. For this reason, we ask that you
do not soak the foot in water before treatment.
• To maintain natural skin protection, do not remove all calluses.
• Ensure the axle can always rotate freely. The axle must not be
permanently blocked, as otherwise the device will become too
hot and may become damaged.
• Apply moisturiser to the treated areas after each use.
NOTE
The device switches off automatically after 20 minutes. After this
time, have a break of at least 15 minutes to prevent the motor from
overheating.
NOTE
The device switches off if an attachment is prevented from moving
for approx. 3 seconds during use. To restart the device, switch it
briefly off and then on again.
Important:
Check the results during the treatment. This applies in particu-
lar for diabetics as they have less sensitive hands and feet.
27