Tipps And Troubleshooting - ECM Manufacture S-MANUALE 64 Bedienungsanleitung

Loosen the screws of the grinder
scale with an Allen wrench
(2.5mm).
Remove the grinder scale.
Unscrew the bracket of the upper
burr. Please note that it may take
some force to do so.
Clean the burrs and the threads
with a brush. You may use a
vacuum cleaner as well.
Make sure, before replacing the
individual parts, that all
components are very clean.
Please make sure that no coffee
grounds remain in the threads,
since it will not be able to be
screwed back together if this is
the case. A drop of silicone based
oil on the thread and on the O-ring
of the removed bracket makes it
easier to reinstall the bracket.
For faster assembly, turn the
upper burr by hand to the lower
one. Then, from this position,
back again in about a ½- ¾ turn.
Next reassemble the grinder dial.
Readjust the chosen grind level
while the grinder is in use.
7

TIPPS AND TROUBLESHOOTING

Should a bean become stuck in the grinding mechanism, you may easily fix this yourself.
1 Adjust the grind to a coarser degree. Turn the grind adjuster counter-clockwise by two full turns.
2 Press the portafilter against the grinding button and grind coffee. The stuck beans should now come
loose.
3 Re-adjust the grind.
In case the coffee shute of your grinder is plugged due to too fine a grind (depending on temperature,
humidity, fat and oil content of the respective coffee), please take the following steps to solve the problem:
Translation of the original German user manual
ENGLISH
32