Sigma EOX REMOTE 500 Betriebs- Und Montageanleitung Seite 71

3.2 EOX
− Loosen the screw of the EOX
− Open the elastic clamp and bend it around the handlebar (31.8 - 35.0 mm).
− Adjust the clamp in a way that the EOX
inside the drivers viewpoint.
− Tighten the screw (Allen Bolt 3mm) with 0.40 Nm.
− Open the clamp of the EOX
− Close the clamp and align the EOX
− Take care that the cable fits the intended guidance at the inner side of the clamp.
− Tighten the screw (Allen Bolt 3mm) (for tightening force please refer to table below).
− Connect the female plug of the EOX
− Connect the male plug of the EOX
REMOTE 500 and EOX
®
® VIEW 1200.
® VIEW 1200 is aligned to the center of the stem and
® REMOTE 500 and place it on the handlebar (22.2 mm).
REMOTE 500 ergonomically fit.
®
VIEW 1200 with the male plug of the EOX
®
VIEW 1200 with the cable of your E-Bike (B).
®
Butler
Out-front
Reverse
A
Reverse
®
REMOTE 500 (A).
®
Handlebar diameter
31.8 mm
31.8 mm
35.0 mm
B
VIEW 1200
Tightening force
0.5 +/- 0.1 Nm
0.5 +/- 0.1 Nm
0.8 +/- 0.1 Nm
ASSEMBLY I 71 EOX APP I 71