Preparation For Use; Attaching The Side Brushes; Unpacking The Dust Box; Installing Batteries In The Remote Control - Makita DRC300 Betriebsanleitung

Preparation For Use

Attaching the side brushes

WARNING
Before attaching the side brushes, make sure that the batteries are
removed from the robotic cleaner.
• If a battery is left inserted in the robotic cleaner, electric shock or injury
may result.
When attaching the side brushes, lay down a mat or something so that the robotic
cleaner and the floor surface will not be damaged.
1. Turn the robotic cleaner upside down.
2. Slide the side brush lock lever to
1. Lock lever 2. Side brush
3. Attach the side brush so that the shaft on the underside of the robotic cleaner
fits the shape of the hole of the side brush.
4. Push the lock lever of the side brush toward
in properly until it reaches the point shown in the drawing.)
• After installation, lift the side brush slightly to see that it does not detach from
the robotic cleaner.
• Attach two side brushes, one on the left and one on the right.

Unpacking the dust box

WARNING
When you open the top cover of the robotic cleaner, make sure that the
batteries are removed from the robotic cleaner.
• If a battery is left inserted in the robotic cleaner, electric shock or injury
may result.
1. Press the open button ( ) to open the top cover.
Be careful because the top cover opens quickly.
(release mark).
1
2
(lock mark) until it clicks. (Push
13
2. Remove the dust box.
3. Remove the packing material.
4. Put the dust box back in the robotic cleaner and push the top cover to close
until it clicks.
When closing the top cover, be careful not to get your fingers caught.

Installing batteries in the remote control

1. While pressing on the lid of the remote control, slide the lid in the
direction shown by the arrow and remove it.
2. Insert the batteries in the correct direction.
ENGLISH