Herunterladen Inhalt Inhalt Diese Seite drucken

Outdoor Unit Installation; Outdoor Unit Installation Instructions - INVENTOR V7LI-12WiFiR7RS-12 Installationshandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Outdoor Unit Installation

Outdoor Unit Installation Instructions

Step 1: Select installation location.
The outdoor u nit should be installed In the lo-
cation that meets the following requirements:
Place the outdoor unit as close to the in-
door unit as possible.
Ensure that there is enough room for In-
stallation and maintenance.
The air Inlet and outlet must not be ob-
structed or exposed to strong wind.
Ensure the location of the unit will not be
subject to snowdrifts, accumu lation of
leaves or other seasonal debris. If possible,
provide an awning for the unit. Ensure the
awning does not obstruct airflow.
The Installation area must be dry and well
ventilated.
There must be enough room to install the
connecting pipes and cables and to access
them for maintenance.
Strong wind
Step 2: Install outdoor unit.
Fix the outdoor unit with anchor bolts (M10)
>60cm / 23.6"
Strong wind
Fig. 5.1
Fix with bolts
Fig. 5.3
The area must be free of combustible gases
and chemicals.
The pipe length between the outdoor and
indoor unit may not exceed the maximum
allowable pipe length.
If possible, DO NOT install the unit where it
is exposed to direct sun light.
If possible, make sure the u nit is located
far away from your neigh bors' property so
that the noise from the unit will not disturb
them.
If the location Is exposed to strong winds
(for example: near a seaside), the unit must
be placed again st the wall to shelter it from
the wind. If necessary, use an awning.
(See Fig. 5.1 & 5.2)
In stall the Indoor and outdoor units, cables
and wires at least 1 meter from televisbns or
radios to prevent static or image distortion.
Depending on the radio waves, a 1 meter
distance may not be enough to eliminate all
Interference.
CAUTION
• Be sure to remove any obstacles that may
block air circulation.
• Make sure you refer to Length Specifications
to ensure there is enough room for installa-
tion and maintenance.
5
Strong
wind
Fig. 5.2
◄ Page 19 ►

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis