Turning The Appliance On; Turning The Appliance Off; Auto-Off; Energy Saving - DeLonghi ECAM20 11 Serie Bedienungsanleitung

softener filter (C4) as described in the section "10. WATER
SOFTENER FILTER". If your model is not provided with a fil-
ter, you can request one from De'Longhi Customer Services.

6. TURNING THE APPLIANCE ON

Please note:
• Before turning the appliance on, make sure the main
switch (A8) on the back of the appliance is in the I position
(fig. 3).
• Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupt-
ed. The appliance is ready for use only once this cycle is
complete.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
(A12) and is collected in the drip tray underneath. Avoid contact
with splashes of water.
• To turn the appliance on, press the
6). The light flashes while the appliance is heating up
and performing an automatic rinse cycle. By circulating hot
water, the appliance heats both the boiler and the internal
circuits.
The appliance is at temperature when the
the coffee lights come on.

7. TURNING THE APPLIANCE OFF

Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A12).
Avoid contact with splashes of water.
To turn the appliance off, press the
appliance performs a rinse cycle then goes off.
Please note:
If the appliance is not used for an extended period, place the
main switch (A8) in the 0 position (fig. 3).
button (B2, fig.
6
light goes off and
button (B2, fig. 6). The
9
Important!
To avoid damaging the appliance, do not place the main switch
(fig. 3) in the 0 position until you have turned the appliance off
with the button.

8. AUTO-OFF

The time can be changed so that the appliance switches off after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To change the Auto-off setting, proceed as follows:
1. With the appliance off and the main switch (A8) in the I po-
sition (fig. 3), press the
until the lights on the control panel come on.
2. Press the button (B3, on the left of the dial B6) until
the lights corresponding to the delay before the appliance
goes off automatically come on:
15 minutes ECO
ECO
30 minutes
1 hour ECO
ECO
2 hours
3 hours ECO
3. Press the button (B8, on the right of the dial) to
confirm the selection. The lights go off.

9. ENERGY SAVING

Use this function to enable or disable energy saving. When en-
abled, the function reduces energy consumption in compliance
with European regulations.
Energy saving mode is active when the green ECO light is on
(fig. 7).
1. With the appliance off and the main switch (A8) in the I
position (fig. 3), press the
down until the ECO light (fig. 7) come on.
2. To disable the mode, press the
the dial). The ECO light flashes.
3. To re-enable the mode, press the
the dial) again. The ECO light comes on steadily.
button (B9) and hold it down
7
button (B7) and hold it
button (on the left of
button (on the left of