Explanation Of Lights - DeLonghi ECAM20 11 Serie Bedienungsanleitung

19. EXPLANATION OF LIGHTS

LIGHT DISPLAYED
FLASHING
FLASHING
FLASHING
POSSIBLE CAUSE
The hot water/steam dial must be
turned (A19)
Insufficient water in the tank (A9). Fill the tank with water and/or insert it correct-
The tank (A9) is not correctly in
place.
The grounds container (A13) is full. Empty the grounds container and drip tray,
After cleaning, the grounds con-
tainer has not been replaced
(A13).
The grinding is too fine and the
coffee is delivered too slowly or
not at all.
If the water softener filter (C4) is
present, an air bubble may have
been released inside the circuit,
obstructing delivery.
18
REMEDY
Turn the hot water/steam dial.
ly, pushing it as far as it will go until it clicks
into place.
Insert the tank correctly and press as far as it
will go.
clean and replace. Important: when removing
the drip tray, the grounds container MUST be
emptied, even if it contains few grounds. If this
is not done, when you make the next coffees,
the grounds container may fill up more than
expected and clog the machine.
Remove the drip tray and insert the grounds
container.
Repeat coffee delivery and turn the grinding
adjustment dial (A2, fig. 10) one click clock-
wise towards "7" while the coffee mill is in
operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
"11.3. Adjusting the coffee mill). If the prob-
lem persists, turn the steam dial (A19) to the
I position and deliver some water from the
cappuccino maker.
Deliver a little water from the cappuccino
maker by turning the steam dial (A19) to the I
position until the flow is regular (fig. 5).