Installing The Appliance; Connecting The Appliance; Setting Up The Appliance - DeLonghi ECAM20 11 Serie Bedienungsanleitung

not use the appliance if it is visibly damaged. Contact De'Longhi
Customer Services.

5.2 Installing the appliance

Important!
When you install the appliance, you should respect the follow-
ing safety warnings:
• The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
• The appliance gives off heat. After positioning the appli-
ance on the worktop, leave a space of at least 3 cm be-
tween the surfaces of the appliance and the side and rear
walls and at least 15 cm above the coffee machine.
• Water penetrating the coffee machine could cause
damage.
Do not place the appliance near taps or sinks.
• Arrange the cord in such a way that it cannot be damaged
by sharp edges or contact with hot surfaces (e.g. electric
hot plates).

5.3 Connecting the appliance

Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional.

5.4 Setting up the appliance

Please note:
• Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the instructions in the section: "16. Setting water
hardness".
Proceed as described:
1. Remove the water tank (A9), fill to the MAX line with fresh
water (fig. 1A) then put back in the appliance (fig. 1B).
2. Place a container with a minimum capacity of 100 ml
under the cappuccino maker (A18) (fig. 2).
3. Plug the appliance into the mains socket and place the
main switch (A8) on the back of the appliance in the I posi-
tion (fig. 3).
4. The light flashes on the control panel (B7, fig. 4).
5. Turn the steam dial (A19) to the I position (fig. 5). Water is
delivered from the cappuccino maker, then the appliance
goes off.
6. Turn the steam dial to the 0 position.
The coffee machine is now ready for normal use.
Please note:
• The first time you use the coffee maker, you need to make
4/5 cups of coffee or 4/5 cappuccinos before it starts to give
satisfactory results.
• To enjoy your coffee even more and improve the perfor-
mance of your appliance, we recommend installing a water
8
1A
1B
3
5
2
4