Preparing The Appliance; Setting Up The Appliance - DeLonghi La Specialista ARTE EC915 Serie Bedienungsanleitung

Before using the appliance, always read the safety warnings.
1. DESCRIPTION
1.1 Description of appliance - A
A1. Main switch (ON/OFF)
A2. Grinding level selector
A3. Beans container
A4. Beans container lid
A5. Accessory door
A6. Water tank lid
A7. Water tank
A8. Power cord
A9. Steam wand
A10. Coffee spout
A11. Hot water spout
A12. Housing for grinding filter holder
A13. Coffee mill outlet
A14. Small cup support
A15. Small cup grille
A16. Cup/mug grille
A17. Cup/mug grille support
A18. Drip tray water level indicator
A19. Drip tray
1.2 Description of control panel - B
B1. Pressure gauge
B2. "No water" indicator
B3. "Descale" indicator
B4. Ground coffee quantity dial
B5. 1 or 2 cup button (to use the corresponding coffee filter)
B6. "OK" button: to deliver the beverage/confirm
B7. "Coffee temperature" button
B8. Function selector dial
• Espresso
• Americano
• Hot water
• Descaling
B9. "Steam" button: to deliver steam
1.3 Description of accessories - C
C1. Filter holder
C2. Dosing and tamping guide
C3. 1 cup filter
C4. 2 cup filter
C5. "Total Hardness Test" paper
C6. Descaler
C7. Softballs (*certain models only)
C8. Milk jug
C9. Cleaning brush
C10. Steam wand cleaning needle
C11. Presser
C12. Pressing mat (*certain models only)
1.4 Optional cleaning accessories recommended
by the manufacturer
For more information, visit www.delonghi.com.

2. PREPARING THE APPLIANCE

Wash all accessories with warm water and washing-up liquid,
then proceed as follows:
1. Insert the drip tray (A19) complete with cup grille (A16)
and relative support (A17) (fig. 1);
2. Extract the water tank (A7) (fig. 2) and fill with fresh clean
water, taking care not to exceed the MAX level (fig. 3).
3. Put the tank back in the appliance.
Important: Never operate the appliance without water in the tank or without the
tank.
Please note: You should customise water hardness as soon as possible following the
instructions in section "7. Settings menu".

3. SETTING UP THE APPLIANCE

1. Plug into the mains socket. Press the main switch (A1) (fig.
4);
2. Place a container with a minimum capacity of 100 ml under
the hot water spout (A11) (fig. 5);
3. Press the OK button (B6) (fig. 6). Delivery begins and stops
automatically. Empty the container.
Before using the coffee maker, the internal circuits of the ma-
chine must be rinsed. Proceed as follows:
4. Place the coffee filter (C3) or (C4) in the filter holder (C1)
5. Attach the filter holder (C1) complete with filter to the appli-
ance. To attach correctly, align the filter holder handle with
"INSERT" (fig. 7), then turn the handle to the right until it is
aligned in the "CLOSE" position;
6. Place a container under the filter holder and steam wand
(A9);
7. Press the OK button (B6). Delivery begins;
8. When delivery has finished, press the steam button (B9)
(fig. 8) and deliver steam for a few seconds to rinse the
steam circuit. For best results, repeat 3 or 4 times. The pur-
pose of this procedure is to purge any water from the circuit
before using steam to prepare a beverage.
The appliance is ready for use.
Please note:
We also recommend rinsing the internal circuits if the appliance is
not used for a long period.
The first time you use the appliance, you need to make 4-5 cups
of coffee before the appliance starts to give satisfactory results.
Pay particular attention to the quantity of pre-ground coffee
16
Cleaner
EAN: 8004399333307