Removing The Appliance; Operation; Preparing For Operation - Inventum IKI7028 Benutzerhandbuch

Induktionskochfeld

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

3. Put the appliance head down on the worktop.

4. Remove the protective film (B) from the tape (A) and put it around the appliance. Make sure

there is a distance of 2 mm to the edge of the glass.

5. Install the fastening brackets (A) to the appliance. Use the screws.

6. Put the appliance in the opening of the worktop.

7. Connect the appliance to the mains supply.

After connecting the display lights up for a short time. The appliance is ready for use.

SETTING THE POWER MANAGEMENT

Use the power management mode to set the total maximum power of the appliance.

Note:

As a default, the appliance is set to 7.4 kW. The possible settings are: 2.5, 3.5, 4.5, 5.5, 6.5 or 7.4.

Note: Setting the power management must be done within 5 seconds after connecting the appliance.

Otherwise unplug the appliance and connect it again.

1. Connect the appliance.

2. Do not turn on the appliance.

3. Press the two buttons booster B and child lock simultaneously.

The letter S will appear in the operation indicator of the front left cooking zone.

4. Press the child lock button again.

The letter S is displayed and the letter E will appear in the operation indicator of rear left cooking zone.

5. Again press the two buttons booster B and child lock simultaneously.

The letters S and E are displayed and the letter t will appear in the operation indicator of rear right cooking zone.

The timer indicator displays the current value.

6. Change the value to the correct setting. Use the booster button.

Note:

To stop setting the power management, do not touch a button for 60 seconds.

7. Press the child lock button to confirm the setting.

You will hear a sound signal when the new setting is confirmed.

8. To exit the power management mode make sure to unplug the appliance and connect it again.